اخبار

خونه > اخبار >

اخبار شرکت در مورد Fixing a Bearing That Won't Fit on a Shaft: Causes & Solutions

حوادث

اخبار

پرونده ها

تماس ها

تماس ها: Ms. Shelley Dong

حالا تماس بگیرید

به ما ایمیل بفرست

2026-03-31

Common Causes

1.Overly Tight Fit: Shaft is too large or bearing bore is too small.

2.Poor Installation: Force applied unevenly or at an angle.

3.Damaged Parts: Shaft or bearing is dented, burred, or out-of-round.

4.No Lubrication: High friction from dry surfaces.

Proven Solutions (In Order)

1.Use the Right Tools.

Press the bearing on using a proper sleeve or adapter that contacts only the inner ring.
Never hammer the bearing directly or press on the outer ring.

2.Apply Heat to the Bearing.

Heat the bearing to 80–120°C (e.g., in an oil bath) to expand its inner ring. This is the most effective method for tight fits.

3.Lubricate the Shaft.

Apply a thin film of assembly paste or light oil to the shaft to reduce friction during the final push.

4.Check Your Measurements.

Use a micrometer to verify the actual shaft diameter and bearing bore match the required tolerance.

If the Bearing Gets Stuck:

Stop immediately. Do not force it.
Remove it carefully with a puller.
Inspect both parts for scratches or debris, clean them, and restart with the correct method.

Prevention Tips

Beining Intelligent Technology (Zhejiang) Co., Ltd

محصولات

نه، نه502جاده سوم شينکسينگ سيکسي لوازم خانگی هوشمند منطقه توسعه صنعتي عالي تکنولوژي، ژجيانگ، چين

لینک های سریع

مشخصات شرکت تور کارخانه کنترل کیفیت اخبار پرونده ها نقشه سایت سیاست حفظ حریم خصوصی

چین کیفیت خوب نردبان های دقیق عرضه کننده. حقوق چاپ 2025-2026 Beining Intelligent Technology (Zhejiang) Co., Ltd تمام حقوق محفوظ است